Which Fixtures Should Be Connected to a Grease Interceptor?
Apr 16, 2017 · The Interceptor Whisperer recommends all fixtures in a commercial kitchen be connected to a grease interceptor to minimize the potential discharge of FOG and to maximize the effort to collect the FOG at the source.
Grease interceptor and commercial sink (oops)
May 24, 2009 · We have sinks on the first floor leading to an air gap and pvc floor drain (w/stainless strainer) leading to another grease trap in the basement far away from the 3c sink. I was going to spray it with fire block foam.
What fixtures should be connected to a grease interceptor?
Different plumbing codes provide specific guidelines regarding which fixtures must be connected to a grease interceptor. Here's a summary of the requirements from the major codes: 1. Uniform Plumbing Code (UPC) Kitchen sinks. Dishwashers (gravity grease interceptors only) Floor drains in kitchens. Pre-rinse sinks. Mop sinks. 2. International ...
floor drains to grease trap? - The Building Code Forum
Jul 22, 2015 · A grease interceptor or automatic grease removal device shall be required to receive the drainage from fixtures and equipment with grease-laden waste located in food preparation areas, such as in restaurants, hotel kitchens, hospitals, school kitchens, bars, factory cafeterias and clubs.
Floor sinks and Grease traps - Love Plumbing & Remodel
Jul 29, 2021 · How would I connect the drain from a floor sink to a grease trap if the floor sink drain is 2 feet under the inlet of the grease trap. If I'm using a grease trap, do I even need a floor drain for the restaurant. The grease trap has to go above ground.
What Sinks and Systems Should Connect to a Grease Trap?
Aug 23, 2017 · Grease traps and grease interceptors should be used to collect all the FOG (Fats, oils, and grease) coming out of your kitchen, so you can stay up to code on your local ordinances. Wondering why to connect all of them? See it broken down below.
Grease Interceptor Sizing and Installation Guidelines
Grease interceptors are installed on “gray” water drain lines and are designed to remove fats, oils and grease (FOG) from wastewater. The retained FOG should be regularly removed or pumped out of the interceptor.
3 compartment sink draining problem with grease trap
Oct 13, 2010 · In either case you might want to check the pipe size of the floor sink/drain. The purpose of a grease interceptor is to CATCH the grease, not hold it until it can be emulsified and flow into the sewer system.
Grease interceptors are installed on “gray” water drain lines and are designed to remove fats, oils and grease (FOG) from wastewater. The retained FOG should be regularly removed or pumped out of the interceptor. The interceptor must be cleaned whenever 25 percent of any chamber becomes filled with FOG or solids.
Grease interceptors are installed on “gray” water drain lines and are designed to remove fats, oils and grease (FOG) from wastewater. The retained FOG should be regularly removed or pumped out of the interceptor.