I am referring to the TIDA-010242 reference design for my 28V system. My system requires 500W. As I understand from the disturbance limits information, the minimum voltage is 12V (1s). You are correct ...

- HALCoGen creates the header file `HL_errata_SSWF021_45.h` which makes use of `uint32` that is defined in `HL_hal_stdtypes.h`, but does not include this header. - F021 Flash API ships the header file ...

Since the 10.1 SDK is due within 2 months, and there are some notable bugs in 10.0, should we wait for a version 10.1 Linux Academy?

I am facing an issue with balancing feature. I am trying to test external cell balancing via AFE through 0x0083 CB_ACTIVE_CELLS() command. It works in one hardware variant and not in other. What could ...

I have written a javascript for adding breakpoint and reading a variable value, using DSS API. As of now I am running that script from scripting console of CCS using loadJSFile command. As I run the ...

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

The random explosion occurred during the power on and off. We observed that the PWM could not be turned off normally to 0V, but was stuck at 5V. This caused the MOS to fail to turn off normally, ...

To troubleshoot, I tried loading it from U-Boot. When using signed remote core firmware, the authentication verification passed successfully. However, when using ...

I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

The max number of iterations is dictated by the number of accumulators in the hardware accelerator. Interference statistics (which uses the accumulators) determines the threshold values to be used in ...

I use FDC2212, I try to measure two capacitance which are CU plane on a PCB. But capacitor interact each other. There is two shielding concept releated on datasheet. But I can not undestand How I use ...

If the device is disabled, but a voltage is present at the VOUT, what is the expected leakage at the VOUT pin (preferrably over PVT)? Bias voltage is 5.3V.