I have a problem with the DAC output: it always stays at 0 volts. To provide some context, I designed and prototyped two bipolar voltage sources using the DAC8812 and two OPA2277 (based on the bipolar ...

For our project, we would like to run our program with the CPU at 32kHz, corresponding to RUN1 or RUN2 modes. However, when we call the function DL_SYSCTL_switchMCLKfromSYSOSCtoLFCLK(false), the ...

As stated in the safety manual, the junction temperature could be measured on ADCB. But the controller has only ADCA and ADCC so is there another way to measure the temperature of the device?

The following is a waveform of a EEG signal collected by me, which has been filtered and displayed in five frequency bands including alpha, beta, etc. I have the following questions about these: ...

The TI YouTube series "Teaching Old Motors New Tricks" is a great source for information. Some even call it the bible of motor control. Sorry, this is not available ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I´ve used Uniflash application to create a standalone command line package (zip) for the XDS100 v3. On another PC, I ran "one_time_setup.bat" and then "dslite.bat ...

I am working with the AM62x-LP evaluation board and have encountered some confusion regarding the flash memory interfaces supported and the configuration observed in U-Boot. 1. Memory Interface ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I have a question about a problem with the kernel I built myself. First, I checked the functionality using the last image on the SK-AM69 platform. (https://dr ...

My project using TDA4 VH + SDK 8.6 before. Secure boot is normal. Now I want to using SDK9.1.The chip has already burned the keywriter. Because sdk8.6 and sdk9.1 use the same keywriter version, So we ...

For using a pad as GPIO please use that as PIN_INPUT. Please confirm if with PIN_INPUT both GPIOs are working as expected.