I have a problem with the DAC output: it always stays at 0 volts. To provide some context, I designed and prototyped two bipolar voltage sources using the DAC8812 and two OPA2277 (based on the bipolar ...

For our project, we would like to run our program with the CPU at 32kHz, corresponding to RUN1 or RUN2 modes. However, when we call the function DL_SYSCTL_switchMCLKfromSYSOSCtoLFCLK(false), the ...

As stated in the safety manual, the junction temperature could be measured on ADCB. But the controller has only ADCA and ADCC so is there another way to measure the temperature of the device?

The following is a waveform of a EEG signal collected by me, which has been filtered and displayed in five frequency bands including alpha, beta, etc. I have the following questions about these: ...

I have a problem with XDS560 v2 Blackhawk JTAG emulator (TMDSEMU560V2STM-EU). When I trying to Test Connection from CCS Target Configuration window I get these errors: [Start: Blackhawk XDS560v2-USB ...

I use CCS Theia 1.3.1 and want to save user data from start address 0x3c00, the data size is small and only need to be written a few times, so it isn't necessary to use the eeprom way, so I uncheck ...

The TI YouTube series "Teaching Old Motors New Tricks" is a great source for information. Some even call it the bible of motor control. Sorry, this is not available ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I followed the porting guide from mmWaveLink docs and managed to run mmWaveDFP on my FPGA. I am running mmWaveLink_SingleChip_NonOS_Example and using SPI communication. MMWL_powerOnMaster and ...

When I was configuring cascading, when I reached the channel configuration step, an error message was displayed as shown in the figure below, and its related meaning ...

I am trying to enable JTAG debugging for beagle bone black with FTDI based JTAG debugger. I got reference to the TI suggested debuggers from the below TI link. https ...

I appreciate your attention to my question. Here’s what I’m trying to do: Ultimately, I want the PC program to load the built DSP image into RAM, boot it, and run it. But before that, I need to verify ...